Mbm-corporation iCREASE PRO Instrukcja Użytkownika Strona 1

icreasePRO Creaser Operators Manual 6-2013 Version 3.0 WWW.MBMCORP.COM 800-223-2508

Gate Fold: Press More > Gate Image > Start Measuring > Physically Run a sheet through the machine for the sensor to measure > Accept >

Perfect Bind Single Hinge: Press More > Perfect Binding Score Image > Enter The Book Thickness > Single Hinge Image > Start Measuring >

Saving Custom Crease Jobs: Press Custom > Enter In Distance For each Crease in mm > Save > Select Position to save in 1, 2, 3, or 4.

FEED TABLE ASSEMBLY DELIVERY TRAY ASSEMBLY INSTALLING THE DELIVERY TRAY The delivery tray is held in place with 2 dowel pins on each fram

ADJUSTING THE FEED RAIL The feed rail on your icreasePRO is designed to adjust easily in case of a problem with crooked feeding. By loosening the fe

FOLDING DIRECTION OF PAPER There is a correct and incorrect way to fold a creased paper. Following the diagram below will show you the correct direct

ADJUSTING THE RAC ROLLERS The RAC rollers are set from the factory and it is NOT recommended to make any adjustments to this without consulting with

CHANGING THE LOWER CREASE DIE The Lower crease die can easily be changed to accommodate thicker stocks(.01 or thicker) by removing the delivery tray,

TROUBLE SHOOTING • POWER DOES NOT TURN ON 1. Check fuse on side cover. 2. Check outlet for power. • POWER TURNS ON BUT HMI DOES NOT LIGHT U

TABLE OF CONTENTS SPECIFICATIONS…………………………………………………………………………………………….1a SAFETY PROCEDURES/CARE & MAINTENANCE.………………………………………………….1b COMPONENT IDENT

ELECTRICAL REQUIREMENTS AND SPECIFICATIONS Power Requirement: 110/220V, 50-60 HZ, AC, Circuit Protection: 3 AMP Circuit Breaker NOTE: Olde

SAFETY PROCEDURES BEFORE USE: • Read through the owner’s manual. Follow instructions CAREFULLY. • NEVER use a wet area. Electric shock could occur.

COMPONENT IDENTIFICATION REFERENCES 2 Feed Table Assembly Touch Screen Delivery Tray Crease Bar Paper Stop Touch Scree

icreasePRO TOUCH SCREEN CONTROLLER THE TOUCH SCREEN CONSISTS OF: 1. MBM Logo and Service Access 2. Start Button 3. Serial

Crease mode Crease mode is used to apply a Compression Crease/Score to a piece of paper. In this mode there are several Automatic Setup selections or

TRANSPORT OPERATION • The Run Button will start the Transport in any given mode. Press it again to stop the transport. Each Mode has a t

Tri-Fold: Press the Tri-Fold Image > Start Measuring > Physically Run a sheet through the machine for the sensor to measure > Accept > Run